Separation Technologies
Information
Feedback
Internals for wet scrubbers and evaporators
Vane type separator - wash systems
Ensepatec offers fully standardized, high-performance and energy-friendly, gas/liquid separations for vertical gas flows.
The separators include designs for pre-separation (bulk entrain ment separation for 2-stage systems) and fine separation (to be used as a polishing stage for 2-stage systems or where the process conditions only require a single-stage device).
The separators eliminate liquid carry-over caused by high gas velocities to protect downstream equipment and ducting against unwanted effects or corrosion, contamination, or pollution caused by the liquid droplet carryover. These separators have a very low pressure loss and can be operated at gas velocities up to 4.5m/s (900 fpm) under atmospheric conditions, allowing for a mal-distribution of the gas stream up to ±30%.
Ensepatec internals for vertical flow include the following types:
Vane type separator T17 - for pre-separation
Vane type separator T27 - for fine separation
Vane type separator T80 - for both pre- and fine separation
The separators are available in the following materials:
Polypropylene, glass-coupled polypropylene, stainless steel (304,316,316L)
We deliver special alloys such as Duplex, Hastelloy or Inconel on special request.
T17, T27 and T80 pre- and fine-separation internals can be used in one of the following applications.
Vertical flow scrubber
Acid gas scrubbers
Falling film evaporator
Oil spray applications
Evaporator / Concentrator
Vertical KO-drums
Dissolving tank scrubber
Metal Passivation and Plating
Exhaust gas cleaning scrubber
Ambient air intake
For detailed technical information about layouts, fixations, installation, etc, please see technical brochure EST-TB.04.